Bear-archery Compound Bow 2014 User Manual download pdf (Page 25)

CAM ADJUSTMENTS

- Adjusting Draw Length -

Dual Cam Systems

The Outbreak and G3 Growth cam equipped bows can

be configured to provide a draw length from16’’-30’’ for

the Outbreak, and 15”-27” in 1” intervals. No bow press

is required to adjust the multidraw cam system. To adjust

the draw length, first remove the socket head cap screw

located in the rotating module. Next rotate the module

to the desired draw length and reinstall the screw in the

corresponding hole. It may be necessary to pull the cable

away from the module to provide clearance for the module

to rotate, see the picture below. Next perform the same

operation on the opposite cam. Be sure that both the top

and bottom cams are set to the same draw length position.

The adjustable cam operates on a sliding poundage scale

where an increase in draw length also provides an increase

in peak draw weight. This allows the bow to grow with

the archer. The chart on the previous page shows the peak

draw weight at each draw length for the Apprentice and

Outbreak bows.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

No comments

Bear-archery Compound Bow 2014 User Manual Page 25