Bear-archery Compound Bow 2014 User Manual download pdf (Page 35)

INITIAL BOW SETUP

Nocking Point and Nock Adjustment

Now that the initial center shot setting is complete, you

need to verify your arrow nocking point. Install the nocking

point or string loop on the bowstring so that when an

arrow is nocked it creates a 90 degree angle to the string.

Another option is to use a process similar to the one used to

determine center shot. With an arrow in the rest and nocked

on the string, firmly hold another arrow against the shelf of

the riser as illustrated. Look down the arrows and verify that

the arrows are parallel. In other words, the spacing between

the two arrows should be the same along the entire length

of the arrows. If not, adjust your nocking point up or down

to correct.

At this time, adjust arrow fletch position to correspond with

the arrow rest you are using. Such adjustments are done

by simply rotating or replacing the arrow’s nock. Carefully

position the nock to provide proper fletch clearance through

the arrow rest. Your local Bear Archery dealer can show you

how to do this or can provide the service for you. Please refer

to the images on the next page for further reference.

Install All Accessories

After your arrow rest and nocking point are installed

correctly you will need to install all other accessories such as

sights, quivers, silencers, peep sights, stabilizers, etc. Before

mounting ANY accessories to the limbs, Refer to page 3 for

important limb information.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

No comments

Bear-archery Compound Bow 2014 User Manual Page 35